Magellan PRO 10 GPS Receiver User Manual


  Open as PDF
of 27
 
Setup
Magellan eXplorist Pro 10 GPS Receiver 7
Bluetooth
®
Bluetooth Interoperability and Compliance Statement
Thisequipmenthasbeentestedbyaqualiedtestfacilityandfoundtocomplywiththerequirementsofthe
BluetoothQualicationBody(BQB)forradio-frequencyemissionsandBluetoothinteroperability.
Bluetooth Pairing
The eXplorist Touch Pro 10 will need to be paired with a Bluetooth-capable device before they can communicate
with each other. Each Bluetooth device comes with manufacturer instructions specifying how place it into
“Discover Mode” and you will need to refer to those instructions when pairing the eXplorist Touch Pro 10 and the
other device.
1. Place the eXplorist and the other Bluetooth-capable device within a few meters of each other.
2. Place the Bluetooth-capable device in “Discover Mode”.
3. Turn on the eXplorist Touch Pro 10.
4. Access the Menu and tap on the Settings icon.
5. Tap on the Bluetooth icon.
6. Tap on “Add” in the lower right corner.
7. A list of Bluetooth devices will be displayed. Tap on the name of the device to be paired with.
8. On the eXplorist Touch Pro, enter the Passkey for the device you are pairing with. (The Passkey
or how to assign a Passkey can be found in the documentation for the Bluetooth-capable device.)
9. Once the Passkey is accepted, a trusted pair is created and both devices can communicate to
each other via Bluetooth.
 previous next