Magellan PRO 10 GPS Receiver User Manual


  Open as PDF
of 27
 
Setup
Magellan eXplorist Pro 10 GPS Receiver 5
Accessing the USB Connector
1. Usingyourngernailat[B],opentheUSBPort
cover. When done, be sure to close the cover
rmlytopreventwaterordirtfromenteringthe
USB port. (Note that the USB connector is
angled up slightly.)
micro SD Card
A micro SD card can be installed in the Magellan eXplorist Pro 10 to store and retrieve data. Please see your
application instructions for details on how to save to or access data from the micro SD card.
Installing a micro SD Card
1. Remove the battery door and batteries.
2. Slide the silver micro SD card retaining plate towards
the top of the receiver.
3. Lifttheretainingplateupwithyourngernail.
4. Insert a micro SD card with the contacts down,
pointing towards the top of the receiver.
5. Close the retaining plate and slide towards the
bottom of the receiver, locking the micro SD card in
place.
6. Reinstall the batteries and replace the battery door.
B
 previous next