Filter
Top Products
Magellan eXplorist Pro 10 GPS Receiver
Setup
Installing Batteries
The Magellan eXplorist Pro 10 is powered by two AA batteries. Alkaline, lithium or rechargeable batteries may be
used but both batteries must be of the same type.
Battery Door Removal
1. Raise the arm [A].
2. Turn the battery door lock counter clockwise a
quarter turn.
3. Lift the top of the battery door until the pivot
point at the bottom releases, allowing the door to
become free from the receiver.
4. Install two AA batteries observing the polarity as
shown in the battery tray.
5. Whenreinstallingthebatterydoorbesuretorst
insert the hinge point at the base of the door.
Pivot the battery door down and lock it in place
by turning the battery door lock clockwise for a
quarter of a turn.
Camera Speaker
A
Pivot Point
Connecting to the USB Port
The Magellan eXplorist Pro 10 can be connected to a personal computer or external power using the USB
connector located at the bottom of the receiver. It has a rubber covering to protect the connector from water or dirt
andshouldalwaysbeclosedrmlywhenthereceiverisnotconnectedtoaremotedevice.