Filter
Top Products
18
Place the transducer into the epoxy, twisting and turning it to force
any air bubbles out from under the transducer face.
The face of the transducer should be parallel with the hull, with a
minimum amount of epoxy between the hull and transducer. After
the epoxy dries, route the cable to the sonar unit.
Speed/Temperature Sensors
This unit can accept as many as two temperature sensors, which can be
used to monitor the temperature of surface water, a live well or some
other location. These units can also accept an optional speed sensor for
showing speed and distance traveled. You, however, can only use one
accessory at a time. If you would like to use a speed sensor and a second
temperature sensor at the same time, you will need a combination device.
NOTE:
The X-96 is packed with a transducer containing a built-in temp
sensor. If you want a speed sensor or additional temp sensor, see the
Accessory Ordering Information in the back of this manual.
If a second temp sensor is used, it must be the model TS-2U. This
model has a fixed electronic address which designates it as the second
of two temp sensors. Dual temperatures are only displayed on the Full
Chart page. The Large Digital page will only display the primary
temperature sensor.
See the following wiring diagram for temperature and speed sensor
combinations.