Filter
Top Products
7
Electrical noise from engine wiring, bilge pumps and aerators can be
displayed on the sonar's screen. Use caution when routing the
transducer cable around these wires.
Good and poor transducer locations.
How low should you go?
For most situations, you should install your transducer so its centerline
is level with the bottom of the boat hull. This will usually give you the
best combination of smooth water flow and protection from bangs and
bumps.
Align transducer centerline with hull bottom.
There, however, are times when you may need to adjust the transducer
slightly higher or lower. The slots in the mounting brackets allow you
to loosen the screws and slide the transducer up or down.
If you frequently lose bottom signal lock while running at high speed,
the transducer may be coming out of the water as you cross waves or
wakes. Move the transducer a little lower to help prevent this.
CAUTION: Clamp the
transducer cable to transom
near the transducer. This will
help prevent the transducer
from entering the boat if it is
knocked off at high speed.
Good location
Good location
Poor angle
Poor location
Good
loc
a
tion
Tra
n
som
Hull bottom
Transducer
cente
r
line