Filter
Top Products
62
The anchor alarm is triggered when you drift outside of a preset radius.
Using the .1 mile as an example, if you're anchored and the boat moves
more than .1 miles, a tone will sound and a message will appear.
1. To set an alarm, press
MENU|MENU|↓ to ALARMS|ENT|ENT.
2. Use ↓ ↑ to select the desired category, then press
ENT to turn on
(check) or turn off (uncheck) the desired Alarm Enabled box.
3. To change distance settings, use
↓ ↑ to select the desired category,
then press →|
ENT to activate the distance dialog box. Press ↑ ↓ to
change the first character, then press → to the next character and re-
peat until the distance is set.
4. When the adjustments are finished, return to the main page display
by repeatedly pressing
EXIT.
IMPORTANT ALARM NOTES
Anchor Alarm - The anchor alarm may be triggered even when
you're sitting still. This can happen when using a small (less than
.05 mile) anchor alarm range.
Arrival Alarm - If you set the arrival alarm's distance to a small
number and you run a route (see the Navigate Routes segment),
this unit may not show navigation data to the next waypoint, once
you arrive at the first one. You may not be able to come close
enough to the first waypoint to trip the arrival alarm.
NMEA 2000 Alarms
The NMEA 2000 Alarm can be set to monitor multiple EP-10 Fuel Flow
and EP-15 Fluid Level sensors. You can set a threshold for each alarm
in its corresponding Percent box. Thresholds give you control over
when the alarm will go off. You may want the alarm to go off when the
black water tank is filled to 75 percent of its capacity, likewise, you
may want to know when the fuel level falls below 30 percent of tank
capacity.
To get to the NMEA 2000 Alarms menu, press
MENU|MENU, select
ALARMS and press ENT. Choose NMEA 2000 ALARMS and press ENT.
1. With the Fluid Level Device window highlighted, press
ENT and use
↑ ↓ to select the device you want to monitor, then press
ENT.
2. To enable the Full Alarm, highlight
FULL ALARM Enabled box and
press
ENT to turn on (check) the alarm. Press → to the Percent box and
press
ENT. Use the ↑ ↓ keys to select the first number, then press → to
move to the next number. When the desired percentage has been en-
tered, press
ENT.