Filter
Top Products
40
To insert a MMC or SD Card
1. Open the card compartment door.
2. Grasp the bottom of the MMC and push the top of the card into the
slot. Once the card is started, use your fingernails to slide it the rest of
the way to the left, until it is firmly seated in the slot.
3. Close the compartment door and fasten the thumb screw finger tight.
Other Accessories
LMS-522c and LMS-527cDF accessories include MMC cards, MMC
card readers and MapCreate™ 6 mapping software for your computer.
MMC card readers are available in USB and parallel port versions.
Two switch boxes are available for this unit. The SB-7X transducer
switch box switches two transducers to one sonar unit. The SB-8X trans-
ducer switch box switches two sonar units to one transducer.
If these accessories are not available from your dealer, see the acces-
sory ordering information on the inside back cover of this manual. Visit
our web site for a complete listing of all the available accessories.
Cleaning Towel
A lint-free microfiber towel is included for cleaning the unit’s screen.
The towel is highly effective in clearing away water spots, smudges and
finger prints. Just wipe the screen with the dry towel — it's not neces-
sary to moisten the towel with water. If the screen is badly soiled, you
may use water or common window or lens cleaners. DO NOT use pol-
ishing compounds or any other abrasive product.
If you lose the towel or wear it out, you can replace it with a similar
microfiber cloth. These are often available where shop towels or auto-
mobile cleaning towels are sold.
Caution:
Cleaning fabrics other than the microfiber towel type may scratch
the screen. Polishing compounds or other abrasive cleaners will
scratch the screen. Damage caused by incorrect cleaning is not cov-
ered by the warranty. You may wash the towel if it becomes soiled
or loses its effectiveness, but do not use fabric softener. Fabric sof-
tener will ruin the towel’s cleaning capability.