Filter
Top Products
85
simulator mode, you will see the chart file name in the Sonar Page title
bar and a play symbol will flash on and off at the right end of the title
bar. To use the simulator:
1. From the Sonar Page, press
MENU|MENU|↓ to SONAR SETUP|ENT|↓ to
SONAR SIMULATOR ENT|ENT.
Main Menu with Sonar Setup command selected (left). Sonar
Simulator menu, with simulator turned on (right).
NOTE:
With Simulate Position checked, the simulator will also
automatically run the GPS simulator (if GPS data was recorded
with the sonar log).
2. To use the default sonar chart log stored in the unit, press
EXIT. The
recorded chart begins scrolling across the screen, just as if you were on
the water.
3. Turn off the Sonar Simulator by pressing
MENU|MENU|↓ to SONAR
SETUP|ENT|↓ to SONAR SIMULATOR|ENT|ENT|EXIT.
The Sonar Page playing a recorded sonar chart in Simulator mode.
Tip:
The Sonar Simulator can use sonar charts recorded (logged) on a
MMC card. (To see how, read the entry in this section on Log Sonar
"Play"
symbol
flashing
Title bar
with chart
file name