Filter
Top Products
37
Front view (left) and side view (right) showing dimensions of the
sonar/GPS unit when mounted on gimbal bracket.
To pass all connectors through the 1" hole, first pass the transducer
connector up through the hole from under the dash, followed by the
antenna connector and any accessory cables. Next, pass the power
cable's bare-wire end down though the hole from the top.
If you wish, you can fill in the hole around the cables with a good
marine caulking compound. No matter what type of installation you
prefer, be sure to leave enough slack in the cables to allow tilting or
swiveling the unit.
Attach the unit to the gimbal bracket using the supplied gimbal knobs
and washers. Attach the cables and the unit is ready to use.
In-Dash Installation
You can mount the unit in the dash with an optional FM-3 In-Dash
Adapter Kit. The kit includes mounting hardware and a template for
cutting the hole.
Millimeter
[Inch]
244
[9.58]
94
[3.61]
56.9
[2.24]
185
[7.34]
37.1
[1.37]