Lowrance electronic LCX-25C GPS Receiver User Manual


 
32
all electrical devices, this unit could be damaged to a
point that it is unrepairable and could even cause harm
to the user when not properly fused.
CAUTION:
Do not use this product without a 3-amp fuse wired into the power
cable! Failure to use a 3-amp fuse will void your warranty.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.
NMEA 2000 Cable Connections
NMEA 2000 is a new buss network specifically designed for boats. This is
a very young industry standard and, at the time of printing, few boats
being built now have a NMEA 2000 buss installed. Over the next few
years, however, NMEA 2000 will become much more common. To help
you get the most out of this technology, your Lowrance unit is designed
to work with a NMEA 2000 network as soon as it becomes available.
Connecting to a NMEA 2000 Network
Your unit can be connected to a NMEA 2000 buss, receiving sensor
information from any Lowrance units attached to the buss. Contact LEI
Extras (look inside back cover for accessory ordering information) for a
NMEA 2000 buss adapter cable if you would like to do this. You can
connect both the unit and antenna module through the antenna's
extension cable (as described earlier), or you can connect the unit directly
to a network port. To do so, attach the adapter cable's manual locking
collar connector to the Network port on the back of the sonar unit and
attach the other end to an available port on the NMEA 2000 buss, as
shown in the following image.
Lowrance unit direct connection to NMEA 2000 buss.
As soon as the unit is connected to the network, it will begin receiving
shared information. Please note the buss must be powered to operate.
(See instructions in this section for more on powering NMEA 2000
buss.)
NMEA 0183 Wiring
(Data cable)
To exchange NMEA 0183 data, this unit has one NMEA 0183 version
2.0 communication port. Com port one (Com-1) can be used to receive
NMEA format GPS data. The com port can also transmit NMEA format
GPS data to another device.
To NMEA 2000
network port
To sonar
unit's Network
socket