Filter
Top Products
7 APRS NETWORKS
TH-D72A/E CONTENTS 59
Although UITRACE using the normal APRS network path of WIDEn-N can be a problem if mobiles
activate their digipeater at the wrong time, it is also so powerful, that it is a shame not to be able to
use it easily if required. For this reason, all APRS mobiles are encouraged to activate the UITRACE
permanently, BUT using the alias of TEMP instead of WIDE. This always makes possible use of the
mobile as a TEMPn-N digipeater while avoiding the problem of adding interference to the normal use
of WIDEn-N
Figure 7-8 Using UITRACE 2
Following are two configuration examples of a fill-in digipeater (fill-in type digipeater) and a WIDE
digipeater (Wide-type digipeater).
Example 1:
This example shows configuration for a typical TH-D72A/E fill-in type digipeater for general use in
routine operation.
• Digipeat
Digipeat(MyCall): On
• UIdigipeat
UIdigi: On
Aliases: WIDE1-1
• UIflood
UIflood: On
Alias: SS or SSS
(where SS or SSS is the abbreviation of state or ARRL section)
Substitution: ID
•UItrace
UItrace: Off
Alias:TEMP
7.4.4 Configuration Examples (USA)
W4DJY-1 W5DJY-1
WB4APR-7 > APK103,
TEMP1-1, WIDE2-2: Test
All mobiles can act as
TEMPn-N digis all the time
if needed for emergency
WB4APR-7 > APK103,
TEMP1*, WIDE2-2: Test
WB4APR-7 > APK103,
TEMP1, W4DJY-1*,
WIDE2-1: Test
WB4APR-7 > APK103,
TEMP1, W4DJY-1, W5DJY-1,
WIDE2*: Test
Not
working