Kenwood DNX9990HD GPS Receiver User Manual


  Open as PDF
of 62
 
8080 81
Return to the Top page
Setting Up
Return to the Top page
Setting Up
Language setup
1
Touch [SET] of [Language] in the User
Interface screen.
Language Setting screen appears.
2
Set each item as follows.
Select Mode
Selects the mode to select a language.
Easy (Default): Selects a language easily.
Advanced: Allows you to select languages for
respective items.*
Language Select
Selects a language.
*Ifyouselect[Advanced]forSelectMode,
thefollowingscreenappears.
GUI Language Select:
Selects the display language used for the
control screen and so forth.
Navigation Language Select:
Selects the language used for navigation.
Text Language Select:
Selects the language used for tag text (song
information).
3
Touch [Enter].
NOTE
•To cancel the language setup, touch [Cancel].
Touch panel adjustment
1
Touch [Touch] in the System Menu
screen.
Touch Panel Adjustment screen appears.
2
Follow the instruction on the screen
and touch the center of each .
NOTE
•To cancel the touch panel adjustment, touch
[Cancel].
•To reset to the initial status, touch [Reset].
Security setup
Aredindicatorwillblinkontheunitafterthe
ACCissettoOFF,warningpotentialthieves.
Ifturnedto“ON”(default),thesecurity
indicatoronthefrontpanelflasheswhenthe
vehicleignitionisoff.
1
Touch [Security] in the System Menu
screen.
Security screen appears.
2
Touch [ON] or [OFF] of [SI].
EXT SW setup
Setuptheexternalswitchpowermode.
1
Touch [EXT SW] in the System Menu
screen.
EXT SW screen appears.
2
Set each item as follows.
SW Name
Sets the name of the external device.
Output Pattern
Sets the power signal output mode among
“Pulse”/“Level”. Default is “Pulse”.
You can set to turn output on/off each time
the button on the EXT SW screen is touched.
See External Device Control (P.88).
Pulse Set
Sets the pulse signal output time.
Outputs 500ms when “1” is set.
Increases by 200ms with each step. Up to 100
steps can be set.
NOTE
•You can enter characters only after you have
applied the parking brake.
•“Pulse”: Generates a single power signal pulse.
•“Level”: Continues output of high power signal.
Setup memory
AudioControl,AV-INSETUP,Camera,and
AudioSETUPsettingscanbememorized.The
memorizedsettingscanberecalledatany
time.Forexample,evenwhenthesettings
areclearedduetoreplacementofthe
battery,thesettingscanberestored.
1
Touch [SETUP Memory] in the System
Menu screen.
SETUP Memory screen appears.
2
Follow the instruction on the screen.
[Lock] / [Unlock]*
Locks or unlocks the AV-IN SETUP, and Audio
SETUP settings.
Yes
Memorizes or recalls the settings.
No
Cancels the function or memorization.
The SETUP Menu screen appears again.
*When[Lock]isselected,youcannotchange
theAV-INSETUP,andAudioSETUPsettings.
Also,thelockedkeymarkisdisplayed
undereachsettingiconinthesetupmenu.
Continued
 previous next