Filter
Top Products
74
English
Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve,
contact your JVC service center.
PROBLEM
The display does not light up.
No sound from speakers.
Sound from one speaker only.
Continuous hiss or buzzing during FM
reception.
Occasional cracking noise during FM
reception.
No colors on the on-screen display.
Howling during record playing.
“OVERLOAD” starts flashing on the
display.
Remote control does not work.
SOLUTION
Plug the power cord into an AC
outlet and/or press
POWER to
set it in the _ON position.
Check speaker wiring and
reconnect if necessary.
Press SPEAKERS 1 and 2 correctly.
Select the correct source.
Press MUTE to cancel the mute.
Check speaker wiring and reconnect
if necessary.
Adjust the balance properly (see
page 19).
Connect an outside FM antenna or
contact your dealer.
Select a new station.
Check with your dealer to be sure
you have the correct antenna.
Check connections.
Move the antenna farther from
automobile traffic.
Connect a PAL TV.
Move speakers away from the
turntable.
Rotate the MASTER VOLUME
control counterclockwise three or
four times then press STANDBY/
ON
on the front panel.
If “OVERLOAD” does not
disappear, unplug the AC power
cord, then plug it back again.
Press STANDBY/ON
on the
front panel then check the speaker
wiring.
If “OVERLOAD” does not
disappear, unplug the AC power
cord, then plug it back again.
If speaker wiring is not short-
circuited, contact your dealer.
Set the selector correctly either to
“AUDIO/TV/VCR” or to “CATV/
DBS.”
Remove the obstruction.
Replace batteries.
POSSIBLE CAUSE
The power cord is not plugged in or the
POWER switch pressed to set it in the
—OFF position.
Speaker signal cables are not connected.
The SPEAKERS 1 and 2 buttons are not
set correctly.
An incorrect source is selected.
Muting is activated.
Speaker signal cables are not connected
properly.
The balance is set to one extreme.
Incoming signal is too weak.
The station is too far away.
An incorrect antenna is used.
Antennas are not connected properly.
Ignition noise from automobiles.
The color system of the connected TV is
not PAL.
Your turntable is too close to speakers.
Speakers are overloaded because of high
volume.
Speakers are overloaded because of short
circuit of speaker terminals.
The remote control mode selector is not set
correctly.
There is an obstruction in front of the
remote sensor on the receiver.
Batteries are weak.
EN63_76.RX-884R[E]/1.PM5 98.3.26, 1:10 PM74