Filter
Top Products
26
English
Assigning Names to Preset Stations
You can assign a name of up to four characters to each preset station. When a preset
station is tuned in, its assigned name will appear on the display.
On the front panel
only
:
1. Tune in a preset station.
See page 25 for details.
2. Press TUNER/SEA MEMORY.
The preset channel number starts flashing for about 5 seconds.
3. Press TUNER PRESET, while the preset channel number is
flashing.
The first character position starts flashing.
4. Turn MULTI JOG to select the first character, while
the first character position is flashing.
You can use characters listed below.
5. Press TUNER PRESET, while a character you want is
flashing.
The next (or previous) character position starts flashing.
6. Repeat steps 4 and 5 to enter up to four characters.
7. Press TUNER/SEA MEMORY while the last selected
character is flashing after you have assigned a name.
To erase the input characters
Insert spaces using the same procedure described above.
CH–
Available characters
Space
CBADEGFHIJKLMNO
SRQTUWVX
Y
Z01234P
87695
MULTI JOG
CH–
VOLUME
CH–
VOLUME
CH–
VOLUME
Note:
If you turn MULTI JOG while the
preset channel number is
flashing, you can change
the preset channel number.
TUNER/SEA MEMORY
MULTI JOG
TUNER PRESET
TUNER PRESET
TUNER/SEA MEMORY
Note on step 3 to 7:
You cannot select any entry
after the indication on the
display stops flashing.
In this case, repeat the
procedure from step 2 again.
EN24_33.RX-884R[E]/1.PM5 98.3.26, 0:07 PM26