JVC RX-884RBK Automobile Alarm User Manual


 
23
English
One Touch Operation
This receiver can memorize the optimum sound settings for each playing source.
About the One Touch Operation
JVC’s One Touch Operation function is used to assign and store different sound settings
for each different playing source. By using this function, you do not have to change the
settings every time you change the source. The stored settings for the newly selected
source are automatically recalled.
The following can be stored for each source:
Volume level (see page 15)
Input attenuator mode (see page 17)
Subwoofer output level (see page 17)
Input mode (see page 18)
Balance (see page 19)
Loudness (see page 19)
SEA modes (see page 32)
DSP modes
3D-PHONIC mode settings (see page 35)
DAP mode settings (see page 38)
Surround mode settings (see page 40 and 43)
Using the One Touch Operation
On the front panel
only
:
To store the sound settings
1. Press ONE TOUCH OPERATION.
The ONE TOUCH OPERATION lamp lights up, then the
previously memorized settings are recalled.
2. Adjust the sound using the functions listed above.
The newly adjusted settings are memorized.
To recall the sound settings
With the ONE TOUCH OPERATION lamp lit, the settings for the
currently selected source is recalled when the source is selected.
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION so that the lamp goes off.
(Even though the One Touch Operation function is canceled, the
recalled sound effects remain active.)
Note:
If the source is FM or AM (MW/
LW), you can assign a different
setting for each band.
ONE TOUCH OPERATION
ONE TOUCH OPERATION
EN14_23.RX-884R[E]/1.PM5 98.3.26, 0:04 PM23