Filter
Top Products
22
English
Note:
This function takes effect only
when playing back a source
using the Dolby Digital.
LFE ATT: 0dB LFE ATT:10dB
MULTI JOG
SETTING
MULTI JOG
Note:
This function takes effect only
when playing back a source
using the Dolby Digital.
2. Turn MULTI JOG to select the crossover frequency level
according to the size of the small speaker connected, while
the indication of the previous step is still on the display.
As you turn it, the display changes to show the following:
CROSS: 80Hz Select this when the cone speaker unit built in the speaker is
about 12 cm (4
3
/4 inches).
CROSS:100Hz Select this when the cone speaker unit built in the speaker is
about 10 cm (3
15
/16 inches).
CROSS:120Hz Select this when the cone speaker unit built in the speaker is
about 8 cm (3
3
/16 inches).
Low Frequency Effect Attenuator Setting
If the bass sound is distorted while playing back a source using Dolby Digital, follow
the procedure below.
On the front panel
only
:
1. Press SETTING repeatedly until “LFE ATT” (Low
Frequency Effect Attenuator) appears on the display.
The display changes to show the current setting.
2. Turn MULTI JOG to select the low frequency effect
attenuator level, while the indication of the previous step is
still on the display.
As you turn it, the display changes to show the following:
LFE ATT: 0dB Normally select this.
LFE ATT:10dB Select this when the bass sound is distorted.
Dynamic Range Compression Setting
You can compress the dynamic range (difference between maximum sound and
minimum sound) of the reproduced sound. This is useful when enjoying surround sound
at night.
On the front panel
only
:
1. Press SETTING repeatedly until “D. RANGE COMP.”
(Dynamic Range Compression) appears on the display.
The display changes to show the current setting.
2. Turn MULTI JOG to select the appropriate item about the
compression level, while the indication of the previous step
is still on the display.
As you turn it, the display changes to show the following:
COMP.: OFF Select this when you want to enjoy surround with its full
dynamic range. (No effect applied.)
COMP.: MID Select this when you want to reduce the dynamic range a
little. (Factory setting.)
COMP.: MAX Select this when you want to apply the compression effect
fully. (Useful at night.)
COMP.: OFF
COMP.: MID
COMP.: MAX
MULTI JOG
CROSS: 80Hz CROSS:100Hz CROSS:120Hz
SETTING
EN14_23.RX-884R[E]/1.PM5 98.3.26, 0:04 PM22