Filter
Top Products
14
English
Basic Operations
The following operations are commonly used when you play any sound source.
IMPORTANT:
When using the Remote Control, check to see if its remote control
mode selector is set to the correct position:
To operate an audio system, TV, and VCR, set it to “AUDIO/TV/
VCR.”
To operate a CATV converter and DBS tuner, set it to “CATV/
DBS.”
Turning the Power On and Off (Standby)
On the front panel:
To turn on the power, press STANDBY/ON .
The STANDBY lamp goes off. The name of the current source (or
station frequency) appears on the display.
To turn off the power (into standby mode),
press STANDBY/ON again.
The STANDBY lamp lights up.
From the remote control:
To turn on the power, press AUDIO .
The STANDBY lamp goes off. The name of the current source (or
station frequency) appears on the display.
To turn off the power (into standby mode), press AUDIO
again.
The STANDBY lamp lights up.
Selecting the Source to Play
On the front panel:
Turn SOURCE SELECTOR until the source name you want
appears on the display.
As you turn the selector, the source changes as follows:
The selected source lamp also lights up.
AUDIO/TV
/VCR
CATV
/DBS
SOURCE SELECTOR
Current source name appears
100 1k 10k
VOLUME
Current volume level
is shown here
Source lamps on the
front panel
DVD
TV SOUND/DBS PHONO
TAPE/MDVCR 1
VCR 2
FM
AM
VIDEO
CD
STANDBY
STANDBY/ON
FM
TV SOUND/DBS
VIDEO
PHONOCD TAPE/MD AM DVD
VCR1VCR2
Note:
When connecting an MD
recorder (to the TAPE/MD
jacks), and a DBS tuner (to the
TV SOUND/DBS jacks), change
the source name appears on
the display. For details, see
page 18.
Selected source name appears
STANDBY
STANDBY/ON
CH–
CNTR
100 1k 10k
DIGITAL
OVER LEVEL
MUTE AUTO
VOLUME
THEATER DRAMA
LIVE CLUB ACTION
DANCE CLUB
HALL HEADPHONE
PAVILION
PRO LOGIC
TUNED
STEREO
FR
EON
LS
L
LFE
S
C
D S P
3D-PHONC
LOUDNESS
ATT
RS
R
S E A
TA
NEWS
INFO
S
C
DIGITAL
LS
L
LFE
RS
R
What are the following
indicators?
When you select the source
encoded with Dolby Digital and
start playback, the following
indicators light up on the display
to show the signal being input to
this receiver. (Only the indicators
for the received signals light up.)
L: Left front channel
R: Right front channel
C: Center channel
LS: Left rear channel
RS: Right rear channel
S: Rear channel (monaural)
LFE: Subwoofer channel
Note:
Pressing the STANDBY/ON
button again turns off the power
(into standby mode) and lights
the STANDBY lamp. A small
amount of power is consumed
in standby mode. To turn the
power off completely, press the
POWER switch to set it in the
—
OFF position on the front
panel.
AUDIO
EN14_23.RX-884R[E]/1.PM5 98.3.26, 0:03 PM14