Filter
Top Products
18
English
Basic Settings
Some of the following settings are required after connecting and positioning your speakers in your listening
room, while others will make operations easier.
IMPORTANT:
When using the Remote Control, check to see if its remote control
mode selector is set to the correct position:
To operate this receiver, set it to “AUDIO/TV/VCR” (except when
selecting the DBS tuner as the source).
Changing the Source Name
When you have connected an MD recorder to the TAPE/MD jacks or the DBS tuner to
the TV SOUND/DBS jacks on the rear panel. Change the source name shown on the
display when you select the MD recorder or DBS tuner as the source.
On the front panel
only
:
1. When changing the source name from “TAPE” to “MD”:
• Turn SOURCE SELECTOR until “TAPE” appears.
When changing the source name from “TV SOUND” to
“DBS”:
• Turn SOURCE SELECTOR until “TV SOUND”
appears.
2. Press and hold LOUDNESS/SOURCE NAME until
“ASSGN. MD” or “ASSGN. DBS” appears on the
display.
To change the source names to “TAPE” or “TV SOUND,” repeat the same procedure
above (in step 1, select “MD” or “DBS” then press and hold SOURCE NAME).
Selecting the Input Mode
When you have connected some components such as CD player, MD recorder, DVD
player and the DBS tuner using digital terminals (see page 12), you need to change the
input mode for these components to the digital input.
On the front panel:
1. Turn SOURCE SELECTOR until the source (CD, MD,
DBS, or DVD) for which you want to change the input
mode from analog input to digital input.
2. Press DIGITAL INPUT to change the input mode.
Each time you press the button, the input mode alternates
between the digital input and analog input.
From the remote control:
1. Press the source selecting button (CD, TAPE/MD, TV/DBS,
or DVD) for which you want to change the input mode from
analog input to digital input.
2. Press ANALOG/DIGITAL to change the input mode.
Each time you press the button, the input mode alternates
between the digital input and analog input.
AUDIO/TV
/VCR
CATV
/DBS
Note:
Without changing the source
name, you can still use the
connected components.
However, there may be some
inconvenience.
– “TAPE” or “TV SOUND” will
appear on the display when
you select the MD recorder or
DBS tuner.
– You cannot use the digital
input (see below) for the MD
recorder and the DBS tuner.
– You cannot use the COMPU
LINK remote control system
(see page 55) to operate the
MD recorder.
SOURCE SELECTOR
SOURCE SELECTOR
DIGITAL INPUT
ANALOG
/DIGITAL
Note:
Once you have set the digital
input for these components, it is
always used every time you
select these components as the
source.
LOUDNESS
SOURCE NAME
DVD VCR1 VIDEOVCR2
CD
TV/DBS
TAPE/MD FM/AMPHONO
EN14_23.RX-884R[E]/1.PM5 98.3.26, 0:03 PM18