Filter
Top Products
13
STARTUP.
iii. Highlight the GPS Satellite Menu button. The GPS receiver will locate
automatically the GPS satellites. This may take some time. You may
see the signal strength and number of satellites seen by accessing
the Satellite Icon on the Main Menu screen. YOU NEED TO HAVE
THE UNIT SEE ATLEAST A 2D OR 3D FIX BEFORE BEING ABLE
TO TRANSMITT YOUR POSITION OR A WAYPOINT.
b. CALIBRATE THE COMPASS
i. Access the COMPASS Menu
1. Once accessed, press and hold the ENTER Button
a. A dialog box will appear and show that the compass is
in Calibration Mode (Calibrating)
2. Rotate the GPS-MIC-1 unit through two 360 degree revolutions
3. Then Press the ENTER Button.
a. A Message will appear if you have successfully
calibrated the unit’s compass.
i. If Not, repeat the process
4. Press MENU to exit.
Congratulations, you have now configured your GPS hand held unit.
You may now start using the system.
OPERATION
With the GPS-MIC-1 unit’s Power turned OFF, and with your two way
transceiver also unpowered, connect the GPS-MIC-1 unit to your two way
radio transceiver using the appropriate radio accessory cable. (sold
separately). Consult the factory if you are not sure which cable to use.