Filter
Top Products
5. Align the AS WX 1 Satellite Weather Receiver’s screw holes over the
pilot screw holes and attach with the #6 - 3/4” Phillips head screws.
Hand tighten only.
NOTE:If the mounting surface is thin or made of a light-weight material, you may
need to add reinforcing material below the mounting surface in order to support
the AS WX 1 Satellite Weather Receiver.
6. Proceed to “Finish Routing the Cable and Check Operation.”
NNoo AAcccceessss UUnnddeerr MMoouunnttiinngg LLooccaattiioonn
No Access Under Mounting describes when you must route the cable to the
side because there is no space for a cable underneath the mounting location.
For Best Performance:Mount the receiver in an area that provides full exposure
to the sky. The effective area of reception is 10° above the horizon, facing south.
It is also important to separate the receiver at least 3 feet from the control head.
1. Determine the best location to mount, then
test route the 20’ (6 m) cable from the
Humminbird
®
control head to the planned
mounting location of the AS WX 1 Satellite
Weather Receiver.
NOTE: 10’ extension cables may be purchased from
Humminbird® if your planned cable route exceeds 20’
(6 m). Maximum cable length, including extension
cables, should not exceed 50’ (16 m). Visit our web
site at www.humminbird.com, or call our Customer
Resource Center at 1-800-633-1468 to purchase
extension cables.
No Access Under
Mounting Location
8
Installation