Filter
Top Products
2-73
4. The indicator light will flash slowly and then rapidly
after HomeLink successfully receives the frequency
signal from the hand held transmitter. Release both
buttons.
5. Press and hold the just
-trained HomeLink button
and observe the indicator light.
If the indicator light stays on constantly, programming
is complete and your device should activate when the
HomeLink button is pressed and released.
To program the remaining two HomeLink buttons,
begin with Step two under “Programming
HomeLink”. Do not repeat Step 1 as this will erase
all of the programmed channels.
If the indicator light blinks rapidly for two seconds
and then turns to a constant light, continue with
Steps 6
-8 following to complete the programming
of a rolling code equipped device (most commonly a
garage door opener).
6. At the garage door opener receiver (motor
-head unit)
in the garage, locate the “Learn” or “Smart” button.
This can be usually found where the hanging antenna
wire is attached to the motor
-head unit.
7. Firmly press and release the “Learn” or “Smart”
button. The name and color of the button may vary
by manufacturer.
You will have 30 seconds to start Step 8.
8. Return to the vehicle and firmly press, hold for two
seconds, and release the programmed HomeLink
button. Repeat the press/hold/release sequence a
second time, and depending on the brand of the
garage door opener (or other rolling code device),
repeat this sequence a third time to complete the
programming.
HomeLink should now activate your rolling code
equipped device.
To program the remaining two HomeLink buttons,
begin with Step 2 of “Programming HomeLink”.
Do not repeat Step 1.