Filter
Top Products
2 - 5
Wincor Nixdorf Terminal Default Settings
Scan the following Plug and Play code to program the scan engine for a Wincor Nixdorf terminal. This bar code sets the
baud rate to 9600 bps and the data format to 8 data bits, no parity, 1 stop bit.
Wincor Nixdorf Beetle™ Terminal Default Settings
Scan the following Plug and Play code to program the scan engine for a Wincor Nixdorf Beetle terminal. The following pre-
fixes are programmed for each symbology:
Keyboard Country Layout
Scan the appropriate country code below to program the keyboard layout for your country or language. As a general rule, the
following characters are supported, but need special care for countries other than the United States:
@ | $ # { } [ ] = / ‘ \ < > ~
Symbology Prefix Symbology Prefix
Code 128 K EAN-13 A
Code 93 L GS1-128 P
Codabar N Interleaved 2 of 5 I
UPC-A A0 Straight 2 of 5 IATA H
UPC-E C All other bar codes M
EAN-8 B
Keyboard Countries
Wincor Nixdorf Terminal Settings
Wincor Nixdorf Beetle Settings
* United States
Albania
Azeri (Cyrillic)
Azeri (Latin)