Honeywell N56XX Automobile Parts User Manual


 
7 - 14
The horizontal bar code offset allows you to offset the horizontal center of the signature capture area. Positive values move
the horizontal center to the right and negative values to the left. Measurements are in multiples of the minimum bar width.
Y - Vertical Bar Code Offset
The vertical bar code offset allows you to offset the vertical center of the signature capture area. Negative numbers indi-
cate that the signature capture is above the bar code, and positive numbers indicate that the area is below the bar code.
Measurements are in multiples of the minimum bar width.
RF Default Imaging Device
The scan engine supports imaging command processing (IMGSHP, IMGSNP, IMGBOX) so that EZConfig-Scanning (see page
9-3) and other applications are able to perform imaging functions as if they were communicating directly with a scanner. To
accomplish this, the scanner uses a menu command called RF_DID (RF Default Imaging Device). RF_DID is the name of the
scanner (BT_NAM) that is to receive imaging commands. The default for RF_DID is “*”indicating that imaging commands are to
be sent to all associated scanners. Change this setting to RF_DIDscanner_name to ensure that they are sent to a particular
scanner. Refer to "Paging" on page 3-7 to generate a report containing the port, work group, scanner name, and address for
each scanner. Refer to "Scanner Name" on page 3-18 set a unique name for each scanner.
Example of Horizontal Offset set to -75X:
Example of Horizontal Offset set to 75X:
Example of Vertical Offset set to -7Y:
Example of Vertical Offset set to 65Y: