Filter
Top Products
3200 User’s Guide 6 - 3
No Check Character
indicates that the imager reads and transmits barcode
data with or without a check character.
When Check Character is set to
Validate and Transmit
, the imager will only
read Codabar barcodes printed with a check character, and will transmit this
character at the end of the scanned data.
When Check Character is set to
Validate, but Don’t Transmit
, the unit will only
read Codabar barcodes printed
with
a check character, but will not transmit the
check character with the scanned data.
Codabar Message Length
Scan the barcodes below to change the message length. Refer to Message
Length on page 6-1 for additional information. Minimum and Maximum
lengths = 2-60. Minimum Default = 4, Maximum Default = 60.
* No Check Character
Validate Modulo 16 and Transmit
Validate Modulo 16, but
Don’t Transmit
Minimum Message Length
Maximum Message Length