Filter
Top Products
1 - 2 3200 User’s Guide
Connecting the Imager with USB
Note: Honeywell recommends connecting the imager end of the cable first and
the host end second.
An imager can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the imager and to the computer.
2. The imager beeps.
3. Verify the imager operation by scanning a barcode from the Sample
Symbols in the back of this manual.
For additional USB programming and technical information, refer to the
Honeywell “USB Application Note,” available at www.honeywell.com/aidc.
USB PC or Macintosh Keyboard
The 3200 linear imagers are factory programmed for a USB interface. If this is
your interface and you do not need to modify the settings, skip to Chapter 3.
If you programmed the imager for a different terminal interface and you want to
change to a USB Keyboard (PC) or USB Keyboard (Mac), scan one of the
following codes to program the 3200 linear imager. Scanning these codes adds
a CR and selects the terminal ID (USB PC Keyboard - 124, USB Macintosh
Keyboard - 125).
USB Keyboard (PC)
USB Keyboard (Mac)