Filter
Top Products
3200 User’s Guide 6 - 1
6
Symbologies
Introduction
This programming section contains the following menu selections. Refer to
Chapter 9 for settings and defaults.
All Symbologies
If you want to decode all the symbologies allowable for your imager, scan the
All
Symbologies On
code. If on the other hand, you want to decode only a
particular symbology, scan All Symbologies Off followed by the On symbol for
that particular symbology.
Message Length
You are able to set the valid reading length of some of the barcode symbologies.
If the data length of the scanned barcode doesn’t match the valid reading length,
the imager will issue an error beep. You may wish to set the same value for
minimum and maximum length to force the imager to read fixed length barcode
data. This helps reduce the chances of a misread.
• All Symbologies • Interleaved 2 of 5
• China Post Code • Matrix 2 of 5
• Codabar • MSI
• Code 11 • Plessey Code
• Code 39 • RSS-14
• Code 32 Pharmaceutical (PARAF)
• Straight 2 of 5 IATA
(two-bar start/stop)
• Code 93
• Straight 2 of 5
Industrial (three-bar
start/stop)
• Code 128 • Telepen
• UPC-A/EAN-13 with Extended
Coupon Code
• UPC A
• EAN/JAN 8 • UPC E
All Symbologies On
All Symbologies Off