Filter
Top Products
70
Set Up Address
The final setup item is accomplished over the telephone. This is the address that the system says when it dials out in an
emergency. Your voice will be recorded on computer chips in the OmniLT controller and saved to be played back in the
emergency message when the system dials out for an alarm.
Pick up an inside phone and press the ' # ' key on the telephone within 3 seconds of picking up the phone. The OmniLT will
respond with a menu. Press 8 on the telephone keypad, then 8. The unit will say "ADDRESS IS:" then the OmniLT will play
back the message stored in the Address memory if one has been entered by your installer.
To record your address, Press 9, then enter the Master code. The OmniLT will say "RECORD ADDRESS", then BEEP. In a
normal tone of voice, say your name and address and any helpful information for locating your house.
"THE JONES RESIDENCE, 1234 JOHNSON STREET, CORNER OF JOHNSON AND THIRD STREET"
The unit will beep after 8 seconds, then play the address back to you. If you are not happy with the sound, re-record by pressing 9
and the Master code. If you would like to hear the address again, press 8 for Play Address.
If you accidentally press 9 but have not entered your Master code and do not wish to record a new address, simply hang up the
phone. The address can be recorded from a local (in house) phone or a remote phone. We suggest using a local phone for higher
sound quality.
¾ When the OmniLT says "record address - beep" any previous address recorded on your system is erased. Always verify
that you have your name and address in your system if you have entered this function.
¾ When recording the address, do not press any touch-tone keys on your phone until the second beep, indicating that
recording is complete. This will cause improper operation when the system dials out. The OmniLT will think that the
tone is a code being entered by the called party and it will stop talking.