Filter
Top Products
38
For trouble restorations, the event log will show the zone name or specific trouble condition and "TRBL RST":
11:57 AM 5/8
BATTERY TRBL RST
The system records each remote access. A remote phone access is when someone calls into the system from an outside phone
line. Remote phone access is also recorded if the system phones out in response to an alarm and the called party enters a code.
The event log displays the code used to access the system and "REM ACCESS":
12:05 PM 5/8
USER NAME REM ACCESS
An event is logged after three unsuccessful attempts are made to log into the system from a remote phone, the OmniLT will lock
out remote telephone access for 1 hour to discourage any further attempts to access the system - See Telephone Control.
Local access of the system using an in-house telephone is not recorded.
The event log will also record each time the PC Access software is used to access the system. The event log displays the code
used to access the system and "PC ACCESS".
Messages
The Message menu is used to show, log, clear, and send text messages and say and phone voice messages.
To enter the Message menu, from the top-level display or from the main menu, press the 8 (MESSAGE) key on the console.
MESSAGE
1=SHOW 2=LOG 3=CLEAR
↓
4=SAY 5=PHONE 6=SEND
↑
Show Message
The 1 (SHOW) key allows you to display the selected text message(s) on the console's top-level display. This can be a helpful
reminder of special events and occasions.
TRASH NIGHT
ENTER MESSAGE
↓
You may enter the message number followed by the ' # ' key to display that message, or simply press the down arrow key to scroll
through a list of messages. Press the ' # ' key to display the selected message:
Mon Feb 21, 00 4:01 PM
TRASH NIGHT
When the message is displayed, the console will beep 4 times and the console LED will flash continuously. You may press the
' * ' key to acknowledge seeing the message. This will cause the LED to stop flashing, however, the message will remain on the
display until it is manually cleared, or cleared by a program.
Log Message
The 2 (LOG) key allows you to store the selected text message(s) in the Event Log. This can be a helpful to keep track of the
times and dates of events and occurrences.
You may enter the message number followed by the ' # ' key to log that message, or simply press the down arrow key to scroll
through a list of messages. Press the ' # ' key to log the selected message.