Filter
Top Products
63
Exit Delay
The Exit Delay is the time, in seconds, that you have to leave your house when you turn on the system. When arming the system
in Day, Night, Away, or Vacation modes, the system will wait this amount of time before arming.
EXIT DELAY: 60
45-180 SECONDS
The default Exit Delay is 60 seconds. You may change it from 45 to 180 seconds.
Exit Time Restart
When Exit Time Restart is set to Yes, the Exit Delay will restart if the same exit zone is violated twice within the original exit
delay. For example, after arming the system if you open the front door to leave, close the front door behind you, and then reenter
through the front door while the exit delay is still in effect, the exit delay will be restarted. This is designed to give you additional
time to exit without causing an alarm. The exit time will only be restarted once within a given arming period.
To configure Exit Time Restart, from the Set Up menu, press the 5 (ARM) key.
EXIT TIME RESTART: 1
0=NO 1=YES
The default setting for Exit Time Restart is “Yes”.
Unvacated Premises
When Unvacated Premises is set to Yes, if the alarm is armed in Away or Vacation mode and no exit zone is violated during the
exit delay (i.e. the premises was not vacated), the system will automatically arm to Day mode at the expiration of the exit delay.
To configure Unvacated Premises, from the Set Up menu, press the 5 (ARM) key.
UNVACATED PREM: 1
0=NO 1=YES
The default setting for Unvacated Premises is “Yes”.
Entry/Exit Chime
When Entry/Exit Chime is set to Yes, the console(s) will beep once when a door on an entry/exit zone is opened, even if the alarm
system is off. This lets you know when someone enters and leaves.
The default setting for Entry/Exit Chime is Yes.
Perimeter Chime
When Perimeter Chime is set to Yes, the console(s) will beep once when a window or any other perimeter zone is opened, even if
the alarm system is off.
The default setting for Perimeter Chime is Yes.
Enable Quick Arm
The Quick Arm feature allows the security system to be armed by pressing the desired mode key twice instead of having to enter
your code.
The default setting for Enable Quick Arm is No.