Filter
Top Products
48
Finally, you are prompted to enter the current date:
ENTER DATE:
MMDDYY
Enter the current date. If the current date is February 8, 2006, enter it as “0 2 0 8 0 6”.
Advanced Control Programming (ACP)
Your OmniLT can be programmed to do automated control and security functions on a time schedule or in response to an event
occurring in the system.
The OmniLT executes programs:
• Once at a certain time on a certain date (One-Time Program)
• On a certain date every year (Yearly Program)
• Repeatedly (Repeating Programs)
• In response to an event (Event Button Programs)
You can also conditionalize programs so that they only run under certain circumstances.
Each automation "program" is a single step in programming automation in an OmniLT system. Each program must specify when
that program should execute and an action to be taken. The program may also specify a condition that must be true for the
program to execute.
Each program can be set up to execute at a certain time of day or on the occurrence of a particular event in the system. When this
time or event occurs, the programmed action will be taken if, and only if, the specified condition is also true at that time.
The Program menu allows you to add, review, change, and delete automation programs. To enter the Program menu, from the
Setup menu, press the 3 (PROG) key.
SET UP PROGRAMS
1=ADD 2=SHOW 3=DELETE
1 = Add Programs
The 1 (ADD) key is used to add new automation programs to the system. When you press the 1 (ADD) key, the Edit Program
menu is displayed which allows the various parts of a program to be specified - See Edit Program. You may edit each part of the
program as specified under Edit Program. Press the ' # ' key at the Edit Program menu to show the newly entered program.
Press the ' # ' key again to save the program, or press the ' * ' key to return to the Edit Program menu to cancel entry of the new
program and return to the Set Up Programs menu.
Once the new program is entered, the display will return to the Set Up Programs menu.
2 = Show Programs
The 2 (SHOW) key is used to review, edit, and delete existing programs. From the Set Up Program menu, press the 2 (SHOW)
key. The display prompts you to specify which program to be reviewed.
1=CTRL 2=SEC 3=BTTN
4=ALL 5=TEMP #=EVERY
Menu 1 - Programs for a particular control unit number
Menu 2 - All Security related programs
Menu 3 - Programs for a particular macro or event button
Menu 4 - Programs for All On/Off functions
Menu 5 - Programs for a particular Temperature zone
Menu # - Displays every program