Filter
Top Products
8
Headset Type - Allows you to choose which accessory
headset or microphone you are using with the unit, or
have the unit automatically detect the type. If using more
than one type of headset or microphone, you will need
to set the unit to ‘Ask When Detected’ before changing
accessories.
GMRS Radio (US versions only) - This feature is not
available on Canadian units. Use this option to turn
On/Off GMRS channels 15-22. Peer-to-peer transmissions
are not available on GMRS channels. See page 2 for more
information on using GMRS channels.
Microphone Sensitivity Adjustment - This option
allows the user to adjust the Internal Microphone and/or
Headset Microphone sensitivity levels to enhance the
audio performance. This adjustment is present only
on units with software versions 2.20 and higher. It is
recommended to set the microphone sensitivity to the
maximum value and then decreases the sensitivity as
needed for optimum audio quality.
Setup Tones - Overview
The ‘Setup Tones’ option displays the Tones Setup
Page. This page changes the audible alerts.
Setup Tones - Options
The following options are available:
Call Tone - When the CALL button is pressed, an atten-
tion tone is transmitted. This option allows you to choose
from one of ten tones.
Roger Tone - When the TALK key is released, a tone is
sent to signify the end of the transmission. This option
allows you to choose from one of four tones, or set the
tone to ‘Off’.
Ring Tone - When an incoming transmission is received,
an attention tone will sound. This option allows you to
choose from one of ten codes, or set the tone to Off. The
Ring tone will not sound again until there has been 45
seconds of radio inactivity.
Setup Radio
Radio Page
Selecting a Ring Tone.
Tone will sound when you
press IN to accept it.
You must obtain a license
to operate on GMRS
channels 15-22.
Tones Setup Page