Filter
Top Products
Installation
Apollo GX50/60/65 Installation Manual
11
MOUNTING TUBE INSTALLATION
Care must be taken when installing the mounting tube to ensure you can properly insert and
secure the unit. There must be a minimum vertical spacing of 0.040 inches between units to
prevent interference with the cam locking mechanisms. Mounting tubes with clearance
dimples help maintain the proper clearance. The mounting tube must be installed with the
clearance dimples pointing up.
Figure 3 - Full Stack Mounting Tube Spacing
The mounting tube should be flush to the instrument panel and allow sufficient clearance for the
back of the bezel of the unit to mount flush to the mounting tube. Sufficient clearance must exist
in the instrument panel opening to allow ease of insertion and removal of the unit. If the back
of the unit bezel does not mount flush to the mounting tube, the connector may not
engage fully.
Secure the mounting tube to the instrument panel structure. Mounting screw heads must not
protrude into the mounting tube. Be sure to use the appropriate screws so the unit will slide in
and out freely. The screws attaching the mounting tube to the instrument panel structure must
not interfere with the insertion of the unit. Failure to prevent interference will result in damage
to the unit or prevent its insertion. Take care that the mounting tube is not distorted when it is
attached to the instrument panel and structural supports. Shims may be necessary to properly
install the mounting tube. If the mounting tube is distorted out of square, the unit may either bind
when being inserted or the cam lock may not engage.