Filter
Top Products
1
GPSmap 76CS
Battery Installation and
Start Up
Important Note
When replacing batteries, use only new or fully charged bat-
teries. Do not mix Alkaline and NiMH batteries. Recharge-
able batteries may typically display less capacity than
disposable batteries.
Remove the batteries from the unit if you don’t plan to
use it for several months. Storing batteries in the unit for
prolonged periods may result in leakage and damage to the
battery compartment.
Follow the manufacturer’s instructions for proper care and
disposal of used batteries. Do not incinerate used batteries,
as internal materials may ignite with explosive violence.
Extensive use of backlighting, WAAS, the electronic compass
and key beep tones will signifi cantly reduce battery life.
To set backlighting intensity and timeout, see page 58.
To disable WAAS, see page 57.
To mute the beep tones, see page 60.
To turn the electronic compass On/Off. see page 15.
Getting Started
Installing the Batteries
The GPSmap 76CS operates on two “AA” batteries (not included),
which are located in the back of the unit. Alkaline or NiMH batteries
(see page 57 for setting the battery type) may be used. Stored data is
not lost when batteries are removed.
T
o install batteries:
1. Remove the battery cover from the back of the unit. Turn the
D-Ring 1/4 turn counter-clockwise and then pull.
2. Insert the batteries, observing the proper polarity. A polarity
diagram can be found molded into the battery compartment.
3. Reinstall the battery cover by reinserting the locking pin in
the back of the unit. Turn the
D-Ring 1/4 turn clockwise to
lock in place.
Battery Compartment
Locking
Pin Slot
Battery Compartment
Cover
Locking D-Ring
Back of
GPSmap 76CS
GPSmap 76CS Owner's Guide copy.indd 1GPSmap 76CS Owner's Guide copy.indd 1 10/8/2004 8:26:25 AM10/8/2004 8:26:25 AM