Filter
Top Products
3. CHANGING SETTINGS
3-2
4. Click the Display mode change button.
Shows direction of detection beam.
Display mode change dialog box
5. In the Display Item window, blue-highlight the display(s) you wish to use. In the Beam
information window you may set the tilt angle and bearing for beams 1 through 5.
6. Click ◄ or ► successively in a Tilt box to set tilt angle (0-degree is vertical).
7. Click ◄ or ► successively in a Bearing box to set bearing (0-degree is ship’s bow).
8. Repeat steps 6 and 7 to set tilt and bearing for other beams.
9. You can change the location of a display screen as follows:
a) In the Layout window, blue-highlight the display you want to change.
b) Blue-highlight the location in the Layout window where you want to move the display
selected at a).
10. Click the OK button to close the display mode change dialog box.
11. If you want to change screen layout format, choose Vertical, Horizontal or Combination
from the Screen layout window.
12. To choose the size of the A-scope display, choose OFF, Small, Standard or Large from
the A-scope window.
13. Click the OK button.