Filter
Top Products
Bettis P/N 124840E
Revision “B”
Page 38 of 46
5.4.2 Using lifting equipment move the power module up to the drive module and align piston rod
(3-40) as follows:
5.4.2.1 G2 through G13 models align piston rod (3-40) with power module extension rod
assembly (1-50).
5.4.2.2 G01 models align piston rod (3-40) with the drive module guide block (1-30).
5.4.3 Using a male square drive extension, go through outer end cap (3-80) and install piston rod
(3-40) as follows:
5.4.3.1 G2 through G13 screw piston rod (3-40) onto extension rod assembly (1-50).
5.4.3.2 G01 only screw piston rod (3-40) onto guide block (1-30).
CAUTION: When screwing piston rod into the G2 through G13 extension rod assembly
(1-50) or G01 guide block (1-30) make certain that the piston rod and extension
rod assembly/guide block threads do not cross-thread.
5.4.4 Torque tighten piston rod (3-40). Refer to Section 3 step 3.3.2 for correct torque value.
5.4.5 Install lock washers (3-110) onto hex cap screws (3-100).
5.4.6 Install hex cap screws (3-100) with lockwashers (3-110) through housing (1-10) and screw
into inner end cap (3-10).
5.4.7 Standard Outer end cap with pipe plug use step 5.4.7.1, outer end cap with extended stop
(ES) use step 5.4.7.2, G2 or G3 outer end cap with M3 or M3HW use step 5.4.7.3 and G01
outer end cap with M3 or M3HW use step 5.4.7.4.
5.4.7.1 Standard outer end cap - Using pipe dope, install pipe plug (3-120) into outer end
cap (3-80).
5.4.7.2 ES outer end cap:
5.4.7.2.1 Screw ES (3-180) into outer end cap (3-80).
5.4.7.2.2 Install ES nut (3-190) on to ES (3-180).
5.4.7.3 G2 or G3 M3/M3HW outer end cap:
5.4.7.3.1 Install M3 adapter (3-280) into outer end cap (3-80).
5.4.7.3.2 Install socket cap screws (3-320) through M3 adapter (3-280) and
into outer end cap (3-80).
5.3.1.4 G01M3/M3HW outer end cap:
5.3.1.4.1 Remove socket cap screw (3-130) from M3 keeper (3-360).
5.3.1.4.2 Remove M3 keeper (3-360) from M3 adapter (3-360) and outer
end cap (3-80).