Filter
Top Products
Bettis P/N 124840E
Revision “B”
Page 30 of 46
4.5.2 If new M3 outer end cap (3-80) is not pre assembled with the M3 then assembly M3 to the
outer end cap (3-80) per Section 3.3 steps 3.3.23.1 or 3.3.23.2.
4.5.3 Install the assembled M3 outer end cap (3-80) per Section 3.3 steps 3.3.23.2.11 or
3.3.23.3.11 and 3.3.24 through 3.3.26.
4.5.4 To install the M3 Handwheel or M3 drive hub refer to Section 3.7.
4.6 ADD AN M3 JACKSCREW TO SPRING MODULE
4.6.1 Remove G-SR (7-10) adapter plate per Section 5.1 steps 5.1.2 and 5.1.3.
4.6.2 If new M3 G-SR adapter plate (7-10) is not pre assembled with the M3 then assembly M3 to
the G-SR cover plate (7-10) per Section 3 steps 3.6.3 or 3.6.4.
4.6.3 Install the assembled M3 adapter plate (7-10) onto the spring cartridge out end per Section
5.2 steps 5.2.11 through 5.2.15.
4.6.4 To install the M3 Handwheel or M3 drive hub refer to Section 3.7.
4.7 ADD AN EXTENDED STOP (ES) TO BLIND END CAP MODULE
4.7.1 Remove blind end cap module per Section 2.4.
4.7.2 If new ES blind end cap module is not pre assembled with the ES then assembly ES to the
blind end cap per Section 3.8.
4.2.3 Install the assembled ES blind end module per Section 3.5.
4.8 ADD AN EXTENDED STOP (ES) TO POWER MODULE OUTER END CAP
4.8.1 Remove outer end cap per Section 2.2 steps 2.2.5 and 2.2.6.
4.8.2 If new ES outer end cap is not pre assembled with the ES then assembly ES to the end cap
per Section 3.8.
4.8.3 Install the assembled ES outer end (3-80) per Section 3.3 steps 3.3.23.3, 3.3.24 through
3.3.26.
4.9 ADD AN EXTENDED STOP (ES) TO SPRING MODULE
4.9.1 Remove G-SR (7-10) adapter plate per Section 5.1 steps 5.1.2 and 5.1.3.
4.9.2 If new ES G-SR adapter plate (7-10) is not pre assembled with the ES then assembly ES to
the G-SR cover plate as follows:
4.9.2.1 Install ES stud (7-40) into adapter plate (7-10).