Filter
Top Products
Instruction Manual MM850481 ed.01
9 CONFIGURATION
Many parameters can be modified using the instrument keyboard. Pressing the [SETUP] key, you can change the
current fuel, include or exclude the CO cell, change the technical unit, set the alarms, etc. The
CONFIGURATION
P1
--- FUEL ---
> LPG
CO SENS. Includ.
FUEL PARAMETER
ESCAPE
–
NEXT
press [NEXT] to change menu page
CONFIGURATION
P2
ENGENEERING UNITS
ALARMS
%O2 REFERENCEs
ESCAPE
–
NEXT
Use the [S] and [T] keys to move the cursor symbol to the desired option.
Press the [ENTER] key to select the option.
Press [ESCAPE] (F1) to return to the previous menu.
Fuel You can select between the pre-set fuel table (LPG, Diesel oil, Oil, Natural gas) or, if
programmed using the configuration PC software, 6 customizable.
CO cell If the CO electro-valve option is installed, you can Include, exclude or automatically select
(using the PC configuration software, you can program the CO level for automatic exclusion)
the CO cell.
Fuel Parameters You can display only all the constant table for the selected fuel. To change the values, you
should use the configuration PC software.
Engineering Unit You can change the technical units for gas, temperature and pressure measurements.
Alarms You can set the alarms levels, Min/Max operation and enable/disable all the 4 possible
acoustic and visible alarms.
%O2 references You can set the %O2 for CO measurements and %O2 for other gas.
9.1 Engineering Units
When you select the Engineering unit option, the following page will be displayed:
MEASURING
UNITS
> CO ppm
Other ppm
Temp. °C
Press. mmH2O
ESCAPE
–
Use the [S] and [T] keys to move the cursor symbol to the desired option.
Press the [ENTER] key to change the value.
Press [ESCAPE] (F1) to return to the previous menu.
The measuring units selectable for gas are: ppm, mg/m3, mg/kWh, g/GJ.
The measuring units selectable for temperature are: °C, °F.
The measuring units selectable for pressure are: hPa, mbar, mmH2O, inH2O.
9.2 Alarms
40