Filter
Top Products
Instruction Manual MM850481 ed.01
Switch the analyzer on.
Keeping the [HELP] key down; press the [X] key to bypass the autozero procedure.
Press [PRINT] then press the [FEED] key for paper feed. Press the [ESCAPE] key when the paper will came out for
same centimeters.
Close the cover inserting the paper end in its slot.
7.9 Pressure decay procedure
(option)
This optional operative mode allows to find pipes leakage. To set and run leak test, press the [MENU] key from
measuring page. The following page will be displayed:
MENU
MEASURE
RECALL MEMORY
FLOW/RETURN TEMP
GAS VEL.
ESCAPE
–
Use the [S] and [T] keys to move the cursor symbol to “MEASURE” option.
Press the [ENTER] key to select the option. Press [ESCAPE] (F2) to return to the previous menu.
MEASURE
P DECAY LEAK TEST
GAS LEAK TEST
AMBIENT CO
ENVIRON. TEMP/HUM
ESCAPE
–
Use the [S] and [T] keys to move the cursor symbol to “P DECAY LEAK TEST” option.
Press the [ENTER] key to select the option. Press [ESCAPE] (F2) to return to the previous menu.
P DECAY LEAK TEST
Leng.: max. 10 mt
Type : Under Track
Diam.: 1/2 "
TEST RESULT
ESCAPE
–
TEST
Before start the test you have to define the plant data:
Leng.: Length of pipes
Type : Type of plant (Under track or Visible)
Diam.: Pipes diameters (from ½” to 1”½ settable)
Use the [S] and [T] keys to move the cursor symbol to the specification to be changed. Press the [ENTER] key to
modify. Press [ESCAPE] (F2) to return to the previous menu.
27