Filter
Top Products
18
diagnostics
The microprocessor at the heart of your security system is constantly
monitoring all of the switches and sensors that are connected to it. It
detects any faulty switches and sensors and prevents them from dis-
abling the entire system. The microprocessor will also record and report
any triggers that occurred during your absence.
arming diagnostics
If the system is armed while an input is active (door open, sensor trig-
gering, etc.) the unit will chirp as per the arm/disarm diagnostic chart
(next page). This is called Bypass Notification.
The security system will ignore the input that was active when the sys-
tem was armed, until the input goes away. Three seconds later the sys-
tem will monitor that input normally.
1. If a door is open the siren will chirp 4 times – 5 seconds after
the arming chirps.
2. If a sensor is active the siren will chirp 4 times – 10 seconds
after the arming chirps.
3. If the hood or trunk is open, the siren will chirp 4 times on
arming.