Filter
Top Products
14
disarm/valet mode
Entering your pin code using the PlainView 2 Valet switch allows you
to disarm the system or enter valet mode without using the transmit-
ter. In valet mode, the security system will not arm, even with the trans-
mitter, but all convenience functions (door locks, trunk release, etc.)
will continue to work normally.
To disarm or enter Valet Mode:
1. Turn the ignition on.
2. Enter PIN code (factory setting is 2 - this
procedure is described later in this manual).
3. After the last digit of the pin code is entered:
a. To disarm the system: press and release
.
b. To enter valet mode: Press and hold
for
three seconds.
The LED status indicator will light steadily when Valet Mode has been
entered.
To exit Valet Mode:
1. Turn the ignition on.
2. Enter PIN code.
3. After the last digit press for one second.
The LED status indicator will turn off when
Valet Mode has been exited.