Filter
Top Products
L (Windshield Washer): See Windshield
Washer on page 209.
5 (Rear Wiper Delay): See Rear Window
Wiper/Washer on page 210.
Z (Rear Wiper): See Rear Window
Wiper/Washer on page 210.
= (Rear Wiper Wash): See Rear Window
Wiper/Washer on page 210.
Turn and Lane-Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow
you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will return
automatically.
To signal a lane change, raise or lower the lever for
less than one second until the arrow starts to flash.
This will cause the turn signals to automatically
flash three times. It will flash six times if tow-haul
mode is active. Holding the turn signal lever for
more than one second will cause the turn signals to
flash until you release the lever. The lever will
return by itself when it is released.
An arrow on the
instrument panel cluster
will flash in the
direction of the turn or
lane change.
As you signal a turn or a lane change, if the
arrows flash more quickly than normal, a signal
bulb may be burned out and other drivers will not
see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows do not go on at all when
you signal a turn, check for burned-out bulbs and a
blown fuse. See Fuses and Circuit Breakers on
page 564.
Turn Signal On Chime
If your turn signal is left on for more than 3/4 of a
mile (1.2 km), a chime will sound at each flash
of the turn signal and the message TURN SIGNAL
ON will also appear in the Driver Information
Control (DIC). To turn the chime and message off,
move the turn signal lever to the off position.
206