Filter
Top Products
feature.
To
restart when you’re already
moving, use
“N”
(Neutral) only.
NOTICE:
Don’t try to shift to
“P’
(Park) if
your Chevrolet is moving. If you do,
you could damage the transaxle.
Shift to
“P”
(Park) only when your
vehicle
is
stopped.
.
Without pushing the accelerator peda
turn your ignition key to “Start.”
When the engine starts, let go of the
key. The idle speed will go down as
your engine gets warm.
NOTICE:
Holding your key in “Start” for
longer than
15
seconds at a time will
cause your battery to be drained
much sooner. And the excessive
heat can damage your starter motor.
,
If your engine won’t start (or starts bt
then stops), it could be flooded
with
too much gasoline. Try pushing your
accelerator pedal all the way to the
floor and holding it there as you hold
the key in “Start” for about three
seconds. If the vehicle starts briefly
but then stops again, do the same
thing, but this time keep the pedal
down for five or six seconds. This
clears the extra gasoline from the
engine.
NOTICE:
Your engine is designed to work
with the electronics
in
your vehicle.
If you add electrical parts or
accessories, you could change the
way the fuel injection system
operates. Before adding electrical
equipment, check with your dealer.
If you don’t, your engine might not
perform properly.
If you ever have to have your
vehicle towed, see the
part
of this
manual that tells how to do it
without damaging your vehicle. See
“Towing Your Vehicle”
in
the Index.
1
Driving
Through
Deep
Standing Water
NOTICE:
If you drive too quickly through
deep puddles or standing water,
water can come in through your
engine’s air intake and badly
damage your engine. If you can’t
avoid deep puddles or standing
water, drive through them very
slowly.
1u
530..