Filter
Top Products
Add coolant mix at the recovery tank, but
be careful not to spill it.
C
Radiator Pressure Cap
NOTICE:
Your radiator cap is a
15
psi (105
kPa) pressure-type cap and must be
tightly installed to prevent coolant
loss
and possible engine damage
from overheating. Be sure the
arrows on the cap line up with the
overflow tube on the radiator filler
neck.
hen you replace your radiator pressure
3p, an
AC@
cap
is
recommended.
I
Thermostat
ngine coolant temperature is controlled
y
a thermostat in
the
engine coolant
{stem. The thermostat stops the
flow
of
3olant through the radiator until the
jolant reaches a preset temperature.
{hen
you replace your thermostat, an
,C@
thermostat is recommended.
I
Power Steering Fluid
Vow
To
Check Power
Steering
Fluid
Jnscrew the cap and wipe the dipstick
vith a clean rag. Replace the cap and
ompletely tighten it. Then remove the
ap again and
look
at the fluid level on
ne
dipstick.
1
When the engine compartment
is
hot,
the level should be near the
H
mark.
1
When the engine compartment is cool,
the I.evel should be near the
C
mark.