Filter
Top Products
Service
&
Appearance
Care
To
Replace
a
Bulb:
(CONK)
3.
Turn
the socket counterclockwise until
it stops. Then pull the socket and bulb
from the side marker light assembly.
4.
Pull the bulb out
of
the socket.
Do
not
twist the bulb.
5.
Plug the new bulb in the socket.
6.
Replace the bulb and socket in the
side marker light assembly.
7.
Replace the assembly in the vehicle.
Replace the bolt.
Center High-Mounted
Stoplight Bulb
Replacement
See “Replacement
Bulbs”
in
the Index to
check the type of bulb to use.
If
you
would like to clean the inside
surface of the rear window or need to
replace a bulb, you can remove the
stoplight housing by following these
steps:
1.
Remove the screws and pull the cover
down.
2.
3.
4.
5.
6.
Lift the locking tabs at the top and
bottom and pull the bulb and socket
out
of
the center high-mounted
stoplight assembly.
Pull the
bulb
from the socket.
Push the new bulb into the socket.
Replace the bulb and socket in the
assembly. Make sure the locking tabs
snap in place.
Replace the cover and screws.
...
182