Filter
Top Products
CHECK OR
SERVICE
Underbody
Flushing
WHAT TO
DO
At least every spring, use plain water to
flush any corrosive materials from the
underbody. Take care to clean
thoroughly any areas where mud and
other debris can collect.
I
Section
C:
Periodic Maintenance
Inspections
isted below are inspections and services which should be
lerformed at least twice a year (for instance, each spring and
all). You should let your
GM
dealer’s service department or
Ither qualified service center do these jobs. Make sure any
ecessary repairs are completed at once.
CHECK OR
SERVICE
Restraint Systems
WHAT TO
DO
Now and then, make sure all your belts,
buckles, latch plates, retractors,
anchorages and reminder systems are
working properly. Look for any
loose
parts or damage. If
you
see anything
that might keep a restraint system from
doing its
job,
have it repaired.’
CHECK OR
SERVICE
Steering,
Suspension and
Front-Wheel-
Drive Axle Boot
and Seal
Inspection
Exhaust, System
Inspection
Throttle Linkage
Inspection
WHAT TO
DO
Inspect the front and rear suspension
and steering system for damaged, loose
or missing parts, signs of wear, or lack
of lubrication. Inspect the power
steering lines and hoses for proper
hookup, binding, leaks, cracks,
chafing, etc. Clean and then inspect the
drive axle boot seals for damage, tears
or leakage. Replace seals
if
necessary.
Inspect the complete exhaust system.
Inspect the body near the exhaust
system. Look for broken, damaged,
missing or out-of-position parts
as
well
as open seams, holes, loose
connections, or other conditions which
could cause a heat build-up in the floor
pan or could let exhaust fumes into the
vehicle. See “Engine Exhaust’’ in the
Index.
Inspect the throttle linkage for
interference or binding, and for
damaged
or
missing parts. Replace
parts as needed.
223
a