Filter
Top Products
0
Use a clean cloth or sponge, and
change to a clean area often. A
soft
brush may be used-if stains are
stubborn.
Use solvent-type cleaners in a
well-ventilated area only.
If
you use
them, don’t saturate the stained area.
0
If a ring forms after spot cleaning,
clean the entire area immediately or it
will set.
Using Foam-Type Cleaner
on Fabric
Vacuum and brush the area to remove
any -loose dirt.
Always clean a whole trim panel or
section. Mask surrounding trim along
stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner
following the directions on the
container label.
0
Use suds only and apply with a clean
sponge.
Ron7 saturate the material.
Don’t rub it roughly.
As
soon as you’ve cleaned the section,
use a sponge to remove the suds.
Rinse the section with a clean, wet
sponge.
0
Wipe
off
what’s left with a slightly
damp paper towel or cloth.
0
Then dry it immediately with a blow
dryer or a heat lamp.
NOTICE:
Be careful with a hair dryer or heat
lamp. You could scorch the fabric.
Wipe with a clean cloth.
Using Solvent-Type
Cleaner
on
Fabric
First, see if you have
to
use solvent-type
cleaner at all. Some spots and stains will
clean
off
better with just water and mild
soap.
If you need to use a solvent:
0
Gently scrape excess soil from the
trim material with a clean, dull knife
or scraper. Use very little cleaner, light
pressure and clean cloths (preferably
cheesecloth). Cleaning should start at
the outside of the stain, “feathering”
toward the center. Keep changing to a
clean section of the cloth.
When you clean
a
stain from fabric,
immediately dry the area with
an
air
hose, hair dryer, or heat lamp to help
prevent a cleaning ring. (See the
previous NOTICE.)
193...