Filter
Top Products
SKU 91315 For technical questions, please call 1-800-444-3353. Page 7
Always keep hands, ngers, and feet away from the moving parts of the
Scissor Lift when applying or releasing a load. Remain clear of the Scissor
Lift when raising or lowering a vehicle.
Use extreme caution when applying or releasing a load. Never allow the load
to suddenly release. Slowly and carefully apply and release the load.
Never leave the Scissor Lift unattended when the Lift is under a load.
Whenever the Scissor Lift is under a load there is a very large amount of force
that has been stored in the Outside/Inside Scissors (24B, 25B) which must be
controlled until the load is relaxed.
Before driving a vehicle onto the Scissor Lift make sure the Lift is fully
lowered. Before driving a vehicle onto the Scissor Lift, position the Plates (42B)
and Rubber Saddles (39B) inward. Do not hit or run over the Plates and Rubber
Saddles, as this could damage the vehicle. Make sure the Scissor Lift is fully
lowered before driving the vehicle off.
Should any weight component be removed from, or added to the vehicle,
use a jack stand (not included) to support the over balanced end during the
maintenance procedure. Do not operate the Scissor Lift if the vehicle load tilts
or binds during the up or down movement. Always position the vehicle with the
center of gravity midway between the Rubber Saddles (39B). Avoid excessive
rocking of the vehicle while it is in its raised position.
Never lift a vehicle with anyone inside it. Do not allow others in the lift area
while operating the Scissor Lift. Do not allow anyone to ride on the Scissor Lift
while it is being raised or lowered.
When lifting a vehicle raise the Rubber Saddles (39B) slowly until the
Rubber Saddles securely contact the vehicle manufacturer’s recommended
lifting points. Then, lift the vehicle to the desired working height. ALWAYS lift
the vehicle high enough for the Safety Lock Assembly (36B) to operate properly.
Do not use the Scissor Lift as a permanent stand for a vehicle. Use the
Scissor Lift only while making repairs. Then, immediately remove the vehicle
from the Scissor Lift.
Before lowering the Scissor Lift, make sure tool trays, stands, and all other
tools and equipment are removed from under the vehicle.
Make sure to squeeze and hold in on the Brake Lever (13B) before
attempting to lower the vehicle. Do not release pressure on the Brake Lever
until the Scissor Lift is completely lowered.
Before removing a vehicle from the Scissor Lift make sure the Plates (42B)
and Rubber Saddles (39B) are moved inward to provide an unobstructed
exit.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.