Filter
Top Products
SKU 91315 For technical questions, please call 1-800-444-3353. Page 5
If the plug does not t fully in the outlet, reverse the plug. If it still does
not t, contact a qualied electrician to install a polarized outlet. Do not
change the plug in any way. Double insulation eliminates the need for the
three wire grounded power cord and grounded power supply system.
Avoid body contact with grounded surfaces such as pipes, radiators,
ranges, and refrigerators. There is an increased risk of electric shock if your
body is grounded.
Do not expose power tools to rain or wet conditions. Water entering a power
tool will increase the risk of electric shock.
Do not abuse the Power Cord. Never use the Power Cord to carry the
tools or pull the Plug from an outlet. Keep the Power Cord away from
heat, oil, sharp edges, or moving parts. Replace damaged Power Cords
immediately. Damaged Power Cords increase the risk of electric shock.
When operating a power tool outside, use an outdoor extension cord
marked “W-A” or “W”. These extension cords are rated for outdoor use, and
reduce the risk of electric shock.
WARNING!
IMPORTANT! A 220V / 50-60 Hz, 12 FLA / Duty Cycle: 5 min, 2 HP /
Single Phase, Dedicated 20A circuit is required. It also requires a
single phase, 3-prong 250V/20A (NEMA L6-20P) power plug (not
included).
THIS WIRING PROCEDURE MUST ONLY BE DONE BY A QUALIFIED,
CERTIFIED ELECTRICIAN!
Symbology
Double Insulated
V~
Volts Alternating Current
Canadian Standards Association
A
Amperes
Underwriters Laboratories, Inc.
n
0
xxxx/min.
No Load Revolutions per Minute
(RPM)
SPECIFIC SAFETY RULES
DANGER! Make sure you know the weight of the vehicle you are
going to lift before using the Scissor Lift. Do not exceed the maximum lift
capacity (6,000 pounds at 48” elevation) for the Scissor Lift. Overloading the
Scissor Lift could cause personal injury and/or property damage. Be aware of
3.
4.
5.
6.
1.
REV 07j