Filter
Top Products
SKU 91315 For technical questions, please call 1-800-444-3353. Page 6
dynamic loading! If a weight suddenly falls onto the Scissor Lift, it may create for
a brief instant an excess load which may result in personal injury and/or damage
to the vehicle and Scissor Lift.
Use the Scissor Lift only in well ventilated areas. Carbon monoxide
exhausted from running vehicle engines is a colorless, odorless fume that, if
inhaled, can cause serious personal injury or death.
Maintain labels and nameplates on the Scissor Lift. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a
replacement. There is a WARNING label attached to the Scissor Lift. Read and
fully understand the contents of the WARNING label. Do not remove the warning
label from the Scissor Lift.
Make sure to read and understand all instructions and safety precautions
as outlined in the manufacturer’s manual for the vehicle you are lifting. All
four Rubber Saddles (39B) of the Scissor Lift must be used when lifting a vehicle.
Always use the manufacturer’s recommended lifting points.
Do not use the Scissor Lift on any asphalt surface. Make sure the Scissor
Lift is used on a dry, oil/grease free, at, level, CONCRETE surface capable
of supporting the weight of the Scissor Lift, the vehicle being lifted, and any
additional tools and equipment. The concrete oor surface should have a
minimum thickness of 5”. The concrete must have a minimum strength of 4,000
PSI, and should be aged at least 30 days prior to use. Do not use the Scissor
Lift on concrete expansion seams or on cracked, defective concrete.
Always examine the Scissor Lift for structural cracks, bends, damage to
the hydraulic hoses and electrical wiring, and any other condition that may
affect the safe operation of the Lift. Do not use the Scissor Lift even if minor
damage is detected.
IMPORTANT! Operation (raising or lowering) of the Scissor Lift can be
immediately stopped at any time by releasing pressure on the Power
Switch located on the Motor (1A).
Make sure the Oil Tank (13A) is completely lled (approx. 6.5 quarts) with a
premium quality hydraulic oil prior to operating the Scissor Lift.
Always allow at least two seconds after the Motor (1A) starts to raise or
lower the Scissor Lift. Failure to do so may cause the Motor to burn out.
Prior to beginning a job, make sure the Safety Lock Assembly (36B) and its
Safety Catches are in the proper position. NEVER work underneath a vehicle
without using additional safety support devices (i.e., jack stands) to support the
vehicle.
2.
3.
4.
5.
6.
7.
8.
9.
10.