Filter
Top Products
SKU 91315 For technical questions, please call 1-800-444-3353. Page 13
Once the repair work to the vehicle is completed make sure to remove all tools,
safety jack stands, and materials from under the vehicle and Scissor Lift. Also,
make sure the work area is clear and it is safe to lower the vehicle.
To lower the Scissor Lift, use the Power Switch and raise the vehicle slightly
to take weight off the Safety Lock Assembly (1C through 11C). Then, release
pressure on the Power Switch. (See Figure D.)
Stand well away from the Scissor Lift and vehicle. Then squeeze and hold in the
Brake Lever (13B) while at the same time pushing in and holding the Pressure
Release Valve Handle (3A) to slowly lower the Scissor Lift all the way down to
the oor. (See Figure D.)
Move the Rubber Saddles (39B) and Plates (42B) inward, out of the path of the
vehicle. (See Figure E.)
Disengage the vehicle parking brake. Start the vehicle’s engine, and drive the
vehicle off the Scissor Lift slowly and carefully.
9.
10.
11.
12.
13.
INSPECTION, MAINTENANCE, AND CLEANING
WARNING! Always unplug the Power Cord from its electrical outlet before
performing any inspection, adjustments, maintenance, or cleaning.
Before each use, inspect the general condition of the Scissor Lift. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring and hoses, and any other condition that may affect its
safe operation. If abnormal noise or vibration occurs, have the problem corrected
before further use.
Do not use damaged equipment.
Daily: With compressed air or a vacuum, remove all dirt and debris from the
Scissor Lift. Also, use a detergent or mild solvent to remove oil and grease from
the unit. Then, use a premium quality, machine oil to lubricate all moving parts.
Daily: Check the level of hydraulic oil in the Oil Tank. The Oil Tank (13A) has a
holding capacity of 6.5 quarts. To ll the Oil Tank, squeeze and hold the Brake
Lever (13B) to release any load on the Scissor Lift. Remove the Oil Tank Fill Cap
on the Oil Tank. Add a premium quality hydraulic oil until the level of oil is even
with the Oil Tank’s ll hole. Then, replace the Oil Tank Fill Cap. (See Figure D.)
1.
2.
3.